Ultrak CCU-100HD Manual de usuario descargar pdf (Pagina 17)

1-1

SECTION 1. INTRODUCTION

1.1 DESCRIPTION

This manual provides the installation, operation, programming, and maintenance

procedures for the CCU-100/HD or CCU-100/HD/X Central Control Unit. The only

difference between the CCU-100/HD and the CCU-100/HD/X is the input power

requirements. The CCU-100/HD is set up at the factory for 110-120Vac power input

and the CCU-100/HD/X is setup for 220-240Vac power input. Throughout this

manual, these units may be referred to as a CCU-100 or simply a CCU. Both units

are available in a rack mount or desk-top chassis.

1.2 FEATURES

The CCU-100/HD Central Control Unit has the following features to control Diamond

Series FastScan/SmartScan assemblies, CRX-500 Series, CRX-600 Series, and

CRX-800 Series Control Receivers, and an Ultrak HD Series Video Switcher.

• Control Input Multiplexing

Control Input Multiplexing means having more than one JPD-100 Joystick

Controller in the system controlling the FastScan/SmartScan assemblies, CRX-

500 Series and CRX-800 Series Control Receivers, and the HD Video Switcher

at the same time. Only one operator can control a receiver at a time. The

operator that requests control of a receiver last gets control. The CCU provides

control input multiplexing for up to four JPD-100 Joystick Controllers.

• RS-485 Control Output

The CCU-100/HD has two RS-485 data outputs for sending control commands to

Diamond series FastScan units, SmartScan units, and CRX-500 or CRX-800

receivers for conventional pan and tilts.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 153 154

Sin comentarios

Ultrak CCU-100HD Manual de usuario Pagina 17