Ultrak CCU-100HD Manual de usuario descargar pdf (Pagina 79)

PROGRAMMING MULTICALLS

4-11

4.3.3.3 M - MultiCall

To program the MultiCall to perform a MultiCall (including itself), perform

the following steps.

NOTE

If the cursor does not automatically move to

the next field after entering data in a field,

press the right gray arrow key to move to the

next field.

1. Enter M in the FUN field.

2. Enter the MultiCall Number (0-255) in the NUM field.

3. Enter a dwell time (00-99 seconds) in the DWELL field.

Dwell time is the amount of time you want the CCU-100 to wait

before it performs the next step in the MultiCall. A "00" dwell time

tells the CCU-100 to perform the functions at the same time. A

"15" second dwell time means that the CCU-100 will wait 15

seconds before performing the next step in the MultiCall.

One MultiCall can start another MultiCall. If a MultiCall calls itself, it

will repeat until halted by an operator. If the MultiCall calls itself,

that step should be the last entry in a MultiCall. Note: Refer to the

JPD-100 Joystick Controller User’s Manual for stopping MultiCalls.

4. Enter another function or press Enter to end programming. If you

pressed Enter, press S to save programming or press Esc to end

programming without saving.

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 153 154

Sin comentarios

Ultrak CCU-100HD Manual de usuario Pagina 79